|Saw Incision Method:|
|Fretsaw: trapezoidal / flat saw blade Incline the teeth of flat saw 45° hard alloy.|
|The diameter of saw blade: 300mm|
|Number of saw teeth: 72 pieces are used to cut 5 boards Leuco Ref: 188389|
|96 pieces are used to excision the fins Leuco Ref: 188390|
|The diameter of saw balde: 250mm|
|Number of saw teeth: 60 pieces are used to cut 5 boards Leuco Ref: 188939|
|80 pieces are used to excision the fins Leuco Ref: 188940|
|Thickness of teeth: 3.0mm|
|Back angle: 15°|
|V- Notch Method:|
|If you want make V-slot in the back of the aluminum composite panel, through the artificial method is easy to mold, use the regulate planer.
Incision rate : 3000-5000 meter/ min
Feeding rate: 25-30 meter/ min
|Using the special incision machine with guide board to make U-notch.
After the process of V-notch, the aluminum composite panel is very easy for hand operation.
|Riveted joint Method:|
Using the usual equipment can rivet and solid fixed, if used outside, the use of heating seals should be taken into consideration. Self-plugging rivet can connect conviently from one direction.
|Operating on flat roof, the bending part can be made very trim. Flat punch, table-flap machine or bending mould are suitable to be the bending equipments. We recommend you to bend with the temperature above 10°C.|
|Concerning the distortion limitation, Company e≥2D, hole diameter(D) and the distance between the center of the hole and panel edge（e）, is the best calculate method.
|Using the table-flap:|
|Using the table-flap, the min inside radius: r=15xt (t means thickness of the panel)
|Using trio-press brake:|
|Comparing to the bable-flap machine, the trio-press brake is fitter for bigger inside radium bending. And if you do it before bending, it can be bended by hand after bending.
|It is easy to drill holes on Aluminum composite panel, in order to realize the best effect, we suggest you use special aluminum and plastic drilling machines.|
Incision angle: 100°- 400°